Actuator Set up Guide with Thanos AMC-AASD15A Servo Controller

Introduction

Actuator Set up Guide with Thanos AMC-AASD15A Servo Controller .You can purchase our 80ST-M2030 or 90ST-M2030 here.The purpose of this quick start guide is to help you configure your AASD servo drive to work with the Thanos Motion controllers. Please feel free to contact us for servo manual.

90ST-M2430 Servo Motor AASD15A Drives 2.4N.m, 3000rpm

80ST-M2430 with AASD15A Servo Drives 90ST-M2430 Servo Motor AASD15A Drives 2.4N.m, 3000rpm

Motor Shield cables

In most cases, the AC servo motor, AASD servo drive, motor power cable, and encoder cable are sold together. Connect the AC servo motor to the AASD servo drive with the included cables per the diagram above. It is recommended to use a shielded motor power cable to prevent EMI issues with other devices.

Thanos AMC Controller Cables

Standard DB25 Male to Male extension cables are used to connect the AASD servo drive to the Thanos AMC controller. Shielded cables are recommended to reduce potential EMI issue.

Reset Factory Defaults

Before configuring your AASD servo drive, it is recommended that you reset the drive to factory defaults

  • Press the Mode (MOD) button until Fn000 shows on the LED Display
  • Select Fn004 using the Up and Down arrow buttons
  • Press and hold the SET button for 3 seconds to enter the function
  • Press and hold the SET button for 3 seconds to reset to factory defaults
  • The LED Display will show “done” if successful and “Err” if the reset failed

AASD Configuration

Set the following parameters on your AASD servo drive to work with the Thanos Motion controllers

Actuator set up guide with Thanos AMC-AASD15A controller

Send us mail